Around the clock, around the town, around the world.
DJ-V57T/E 144MHz 5W / 430MHz 4.5W FM Handheld Transceiver
Double Your Radio Fun with this Tough Talker Dual Band HT!
Click this image to download
a brochure in PDF(419kb)
2m/70cm dual-band hand held transceiver Choice of 3 power output levels: High 5W(13.8VDC), Low 0.5W and user-selectable Mid-power (1-3W) Quick-write memory channel (Uses a single key touch to copy current VFO data to the Lowest number of memory channels available) Direct frequency input through illuminated keypad High-grade water-resistant materials compatible to IPX7 Rugged polycarbonate body resists dirt and dust Great audio with large 40mm internal speaker Easy-to-read backlit alphanumeric display 200 Memories, plus one call channel on each band VFO, Memory and Scan modes 39 CTCSS tone squelch (encode + decode) and 104 DCS Search-scan (programmed scanning) available on each band Tone burst function (1000, 1450, 1750 and 2100Hz) Battery-drain function avoids memory effect Two-touch repeater-setting access Internal VOX Wire cloning capability SMA antenna port 2-level attenuator DTMF encode and auto-dialer
* The IEC 60529/IPX7 is an European system of test specification standards for classifying the degrees of protection provided by the enclosures of electrical equipment. An IPX7 designation means that the unit withstands immersion in one meter (approx 3ft) of still water for up to 30 minutes. The factory guarantees this grade for 1 year provided all the jack covers are properly and securely closed. However, Please understand that unit is not an IPX8 (water-resistant) grade, NOT even IPX7 COMPLIANT (but compatible); water-pressure such as washing the unit with running water may cause damage to the unit and voids warranty. Never immerse the unit uselessly under the water. V/UHF signal does not propagate in water. If the unit is dropped in water, please pick it up immediately and wipe with a clean dry cloth
|
|
|
[T: RX] 136 - 173.995MHz, 400 - 511.995MHz [E: TX/RX] 144 - 145.995MHz, 420 - 439.995MHz |
|
(Typical value) |
RX at 500mW AF out: 250mA Stand-by: 80mA Battery-save ON: average 27mA |
Battery packs: -10digC to +45digC (+14digF to +113digF) |
|
|
|
|
(Approx.value) |
Battery packs (7.2 - 7.5Vdc): VHF5W - UHF 4.5W / 2W / 0.5W |
|
|
|
Specifications subject to change without notice or obligation. Specifications apply to Amateur Radio bands only. Permits required for MARS use. |
|
Standerd Accessories
T-version : AC adapter EDC-146 / Belt clip / EBC-22 / Rubber duck antenna EA-114 / Carry strap / Ni-MH Battery pack EBP-65 (7.2V 700mAh) E-version : Battery Charger EDC-159E / Belt clip EBC-22 / Rubber duck / antenna EA-114 / Carry strap / Li-ion Battery pack EBP-63 (7.4V 1100mAh)
Accessories may differ depending on the versions. Please contact your dealer for standard accessories and warranty-policy.
Optional Accessories
EBP-63 : Li-ion Battery Pack (DJ-V57E Standard / DC 7.4V 1100mAh) EBP-64 : Li-ion Battery Pack (DC 7.4V 1600mAh) EBP-65 : Ni-MH Battery Pack (DJ-V57T Standard / DC 7.2V 700mAh) EBP-66 : Ni-MH Battery Pack (DC 7.2V 2000mAh) EDC-36 : Mobile Cigarette Lighter Adapter with Active Noise Filter EDC-37 : External DC Power Supply Cable EDC-43 : Mobile Cigarette Lighter Cable for Charging Ni-MH Packs EDC-146 : Wall Charger (120V) EDC-147 : Wall Charger (230V) EDC-148 : Wall Charger (230V U.K. Plug) EDC-143T/E/UK : Ni-MH Trickle Battery Charger (T:120V / E:230V / UK:230V UK plug) EDC-144A/E/UK : Rapid Battery Charger (A:120V / E:230V / UK:230V UK plug) EDC-159T/E : Rapid Li-ion Battery Charger (T:120V / E:230V) EDC-160T/E : Rapid Ni-MH Battery Charger (T:120V / E:230V) EDH-34 : Dry Cell Case EA-114 : Whip antenna (as a spare part) EDS-10/14 : Microphone/Speaker Cable EDS-11 : Clone Cable EME-4 : Earphone Microphone* EME-6 : Earphone* EME-26 : Earphone* (curl-cord) EME-12A : Headset with VOX* EME-13A : Earphone and MIC with VOX* EME-15A : Tie-pin MIC with VOX* EME-23 : Earphone Microphone* EME-32A : Heavy-duty Earphone Microphone EME-34A : Earphone Microphone* EME-36A : Earphone Microphone EMS-47 : Speaker Microphone with Audio Control* EMS-59 : Speaker Microphone* EMS-62 : Speaker Microphone ERW-4C : PC Programming cable (serial port)* ERW-7 : PC Programming cable (USB port)* ESC-41 : Soft Case (For all battery packs)
* EDS-10 or 14 required to use these accessories.
DJ-V57 Free Utility Software Download
Please be advised that this is a freeware (copyright reserved by Alinco, Inc). Although we have tested this software on our Windows XP/Vista/Seven 32bit environments and experienced no serious accident during the operation, we are not responsible of any eventual damage caused to your radio and/or PC system by using this utility. Sorry, please do not contact us for how to use the software, as this is a very simple editor software. The updates will be posted here as soon as available. Please uninstall the older version before you install the latest one in case of update. In case you find a bug, please report to export@alinco.co.jp specifying your OS.
This utility enables you to program frequencies, set parameters and save it in your PC for any version of DJ-V57.
DJ-V57 Clone Utility (3.1MB/Ver 0.00 beta Sept 2011 Installer program and instruction manual in PDF)
Please remember that you must have Alinco's optional EDS-14 or EDS-10 plug-conversion cable and either ERW-4C or ERW-7 computer interface cable in order to connect the unit to your PC. A simple connection cable may not work properly.